Operation Modes - Teac TASCAM TT-M1 Mode D'emploi

Operation Modes

The TT-M1 has two operation modes: the
turntable mode and the scratch mode.
To switch these operation modes, press the
SCRATCH key on the CD-X's remote controller.
The TT-M1 is in the turntable mode when the
SCRATCH key is turned off, and it is in the
scratch mode when the key is lit up.
Turntable mode (SCRATCH key: off)
All the transport control of the CD-X is per-
formed on the TT-M1 (turntable). Track
searching, locating to the CUE and CUE 1-3
points, and the flash start function can also be
operated from the CD-X's remote controller.
Scratch mode (SCRATCH key: on)
In addition to the operations in the turntable
mode, the transport control of the CD-X can
be performed with the CD-X's remote con-
troller when the turntable is stopped.
Scratch Playback
1 Turn on the CD-X and load a CD.
2 Lower the TT-M1 roller onto the turntable
and press the POWER switch.
• A record does not have to be placed on the
turntable.
The LED comes on and the following is dis-
played on the CD-X's remote controller:
3 Turn the turntable on to rotate at 33 rpm.
4 Switch the operation modes by pressing the
SCRATCH key on the CD-X's remote con-
troller.
5 Play the desired tune on the CD-X and con-
duct scratching on the record player.
6 To stop scratch playback, stop playing the
CD and rotating the turntable.
If CDs are played too slowly or too quickly
• Is the pitch control of the record player set to
the normal position?
• Has the TT-M1 been calibrated?
English 5