Hard-Wire Installation; Completing The Installation - Reliance Controls PRO/TRAN 2 A304 Manuel D'utilisation

Hard-wire Installation

"Hard-wire" installation to a power inlet box located remotely from the transfer switch (Figure
5) requires additional steps to complete the installation. The wire connections to the wires
from power inlet box are made in the circuit breaker compartment of the transfer switch.
Access the circuit breaker compartment by removing the two screws located on the sides of
the lower circuit
compartment cover. Replace when
installation is complete.
From the transfer switch, connect:
the black wire lead to the
power inlet X or Y terminal
the white wire lead to the
power inlet neutral W terminal
the red wire lead to the power
inlet X or Y terminal
the green wire lead to the
power inlet ground G terminal.
Inlet Installation (For indoor models installed outdoors)
Suffix A and B models have a power inlet included. The inlet can be installed on the unit
by removing the circuit breaker compartment cover (described in the proceeding section)
and the power inlet filler plate, installing the inlet with the enclosed screws onto the wiring
compartment cover, and connecting the wire leads to the inlet as described in the
instructions included with the inlet. Make sure the unit is installed in a dry location.

Completing the Installation

When you have wired all the load circuits in the transfer switch, only the white neutral wire
and the green ground wire remain.
1. Insert the white neutral wire into an unused opening in the neutral bar in the load
center and tighten the screw (Figure 4).
2. Insert the green ground wire into an unused opening in the ground bar, if existing, and
tighten the screw. If no ground bar exists, insert the green wire into an unused hole in
the neutral bar and tighten the screw.
3. Replace the cover to the load center.
4 Fill in the chart on the transfer switch to identify your emergency circuits and
corresponding circuit numbers in the load center.
5 Return all load center branch circuit and main breakers to the "ON" position.
6 Move all circuit selector switches on the transfer switch to the
"LINE" position.
Installation is now complete.
breaker
7