Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 20
2. Continual Drainage
the water reservoir can be automatically emptied via a drain by connecting a water
hose to the machine. (circumference: 12 mm, not included).
the outlet for the drain is located on the back of the machine.
1. Pull the rubber stopper out of the opening.
2. insert the water hose through the opening into the machine. connect the hose
tightly to the drainage outlet and make sure that the connection is tight and that no
water can leak out.
3. Lead the hose to the location to which the water is destined, such as a floor drain.
make sure that this point is lower than the drainageoutlet.
4. make sure that the hose runs vertically, so that the water can drain quickly. in
other words, there should be no kinks in the hose. (see figures)
NOTE: when this continual drainage is not used, make sure that the rubber
stopper is not in the drainage hole.

MAINTENANCE AND CLEANING

turn off the machine and pull the plug from the outlet before cleaning the machine.
1. Grill and Housing
use water and a mild detergent to wipe the grills and the housing clean. Do not use
bleach water or abrasive agents.
Do not pour or spill water directly onto the machine. this can cause electrical shock,
damage to the insulation or rust on the machine.
the grills where the air enters and exits can easily become soiled. use a vacuum
cleaner accessory or a brush to clean it.
2. Water Reservoir
clean the water reservoir regularly to prevent the growth of mould and bacteria.
Partially fill the water reservoir with clean water and add a bit of mild detergent. Rinse
the reservoir with this solution, pour the solution out, and rinse the reservoir.
After cleaning, the reservoir must be replaced correctly into the dehumidifier so that
the machine will function.
51
DO342DH

Publicité

Table des Matières
loading

Table des Matières