Control Panel - Domo DO342DH Mode D'emploi

DO342DH

CONTROL PANEL

Buttons
1. On/Off Button
Press this button to turn the dehumidifier on and off.
When you turn the machine on, the 'power' light will
turn on and the display will show the air humidity
percentage at the moment.
2. Buttons to set the air humidity
the air humidity can be set from 35% relative humidity to 80% relative humidity at
5% intervals. for dryer air, press the down arrow and set the air humidity to a lower
percentage. (min. = 35)
for moister air, press the up arrow and set the air humidity to a higher percentage.
(max. = 80)
the ideal humidity in the house falls approximately between 40% and 60%.
3. Button for continual use
Press this button to let the dehumidifier run continuously for a maximum
dehumidification until the water reservoir is full. The buttons to set the air humidity
cannot be used when the device is set to «continual». Press this button again to cancel
continual operation. You can also go back and use the buttons to set the humidity.
Indicator Lights
the blue «power» light indicates that the machine is on.
the red «full power» light indicates that the water reservoir of the machine is full and
needs to be emptied.
the blue 'cont.' light indicates that the machine is set for continual operation.
Display
the standard setting for the display indicates the air humidity in the chamber to
an accuracy of approximately 5%. When you select the humidity yourself with the
buttons provided, you will always see the desired humidity percentage for which the
machine will be set.
Error Messages:
e1: humidity sensor error: Pull the plug from the outlet and plug it in again. if the
error message repeats, have the machine looked at.
e2: temperature sensor error: Pull the plug from the outlet and plug it in again. if the
error message repeats, have the machine looked at.
3
48
2
1
2