Product Information; Application Instruction; Spare Parts List - IKA S 65 KD-G 65 G Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

CAUTION
risk of splashing and evaporation of liquids; body parts, hair, clothing and jewelry
getting caught.
• The work has to be interrupted immediately if you notice unusual noise and/or
increasing emission of liquid from the upper, sidewise rinsing drilling. The bearings
must be controlled, and replaced if necessary.
• Note the operating instructions of the disperser unit.
• Abrasion of the dispersion equipment or the rotating accessories can get into the
medium you are working on.
• Do not use any damaged dispersion tools.
NOTICE
• The dispersion tool is not suitable for continuous operation. Likewise the optimal
dispersion duration and rotating frequency must be determined by attempts. Usu-
ally a few seconds are sufficient, maximum duration is one minute. Longer ap-
plication times bring no improvements, increase however the sample temperature
substantially.
• Dispersing causes the medium to heat up.
• Note the min./max. immersion depth in the "Technical data".
• The function of the dispersion tools depends on the condition of the sharp edges of
rotor and stator (integrated in the shaft tube). Abrasive media can round off these
edges fast, whereby the disperse effect diminishes.
S65 KD: The shaft bearing of the dispersing tool consist of a ball bearing. The dis-
persing tool is sealed by means of a sealing ring.
S65 C: The shaft bearing of the dispersing tool consist of a ball bearing on the top
and a ceramic slide bearing at the bottom.
All materials are FDA (Food and Drug Administration) conform.
Application: Wet crushing, dispersions, emulsifying (Batch-operation).
S 65 KD:
Item Designation
1
Plastic cap
2
Shaft
3
Shaft tube
4
Bearing
5
Sealing
6
Bushing
7
O-ring
8
Shaft sleeve
9
Coupling
11
O-ring
15
Nut
16
Dissolver
17
Rotor
18
Stator
19
Blade
Wear your personal protective equipment in accordance with
the hazard category of the medium to be processed. There is a
Never run the dispersion tool dry. Without cooling by the me-
dium the sealing will be destroyed.

Product information

Application instruction

Spare parts list

S 65 C:
Item Designation
1
Plastic cap
2
Shaft
3
Shaft tube
4
Bearing
6
Bushing
8
Shaft sleeve
9
Coupling
11
O-ring
13
Bushing
15
Nut
16
Dissolver
17
Rotor
18
Stator
19
Blade
Spare parts diagram see front page.
For orders of spare parts, please
specify the type of dispersion tool
and the designation of the spare
part.
Note to S 65 KD:
During commissioning, after in-
serting a new sealing (5), can lead
to increased wear.
9

Publicité

Table des Matières
loading

Table des Matières