Installation Instructions; Unpack Refrigerator; Reduce Tipping Radius; Move The Refrigerator Into House - Dacor Discovery DYF42BIWS Instructions D'installation

Unpack Refrigerator

WARNING
Tip Over Hazard
Refrigerator is top heavy and tips easily when not
completely installed.
Keep doors taped closed until refrigerator is
completely installed.
Use two or more people to move and install
refrigerator.
Failure to do so can result in death or serious injury.
IMPORTANT:
If you receive a damaged product, immediately contact your
ƒ
dealer or builder. Do not install or use a damaged appliance.
Do not remove the film on the outside until the refrigerator is in
ƒ
its operating position.
All four leveling legs must contact the floor to support and
ƒ
stabilize the full weight of the refrigerator.
Keep the cardboard shipping piece or plywood under the
ƒ
refrigerator until it is installed in the operating position.
1. Remove and save the literature package bag taped to the side
of the refrigerator and the parts bag behind the grille. Remove
the four brackets (two on each side) that attach the shipping
base to the refrigerator bottom.
NOTE: Do not remove tape and door bracing until the
refrigerator is in its final position.
2. If necessary, reduce the tipping radius. See Tipping Radius for
ceiling height requirements or Reduce Tipping Radius for step-
by-step instructions. If you do not need to reduce the tipping
radius, proceed to Move the Refrigerator into House.

Reduce Tipping Radius

(if required)
Before bringing the refrigerator into the home, be sure there is
adequate ceiling height to stand the refrigerator upright. See
Tipping Radius.
If you do not have adequate ceiling height to stand the refrigerator
upright, the tipping radius can be reduced by removing the top
grille and side trims (see the following chart).
Model
DYF42BIWS
DYF48BIWS
8

Installation Instructions

Reduced Tipping Radius
90½" (229.9 cm)
91¼" (231.8 cm)
1. Grasp both ends of the top grille.
2. Push the top grille straight up, then pull straight out. Lay the
grille on a soft surface.
B
A. Top grille
B. Cabinet side trim
3. Remove the six screws attaching each cabinet side trim to the
refrigerator and remove the side trims.

Move the Refrigerator into House

WARNING
Tip Over Hazard
Refrigerator is top heavy and tips easily when not
completely installed.
Keep doors taped closed until refrigerator is
completely installed.
Use two or more people to move and install
refrigerator.
Failure to do so can result in death or serious injury.
1. Place an appliance dolly under the left side of the refrigerator
as shown. Be sure to avoid damaging the side trims and
handles. Place the corner posts from the packing materials
over the trims and handles as appropriate. Slowly tighten the
strap.
2. Place pieces of the shipping carton
on the floor when rolling the dolly
and refrigerator into the house.
Move the refrigerator close to the
built-in opening.
3. Place top of cardboard carton or
plywood under the refrigerator.
4. Stand the refrigerator up. First,
place the left bottom edge of the
refrigerator on the floor, stand
the refrigerator upright and then
lower the right-hand side of the
refrigerator to the floor.
5. Reassemble the trim and top grille after the dolly has been
removed from the refrigerator.
B
A