Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation
Registering a camera unit
You must register the camera unit to your monitor unit before it can be
used.
1
Monitor unit:
MMENUN a MbN: "Camera Management" a MOKN a MbN: "Add
Camera" a MOKN
R An operation guide is displayed. Press MOKN to continue.
R Complete the following step within 90 seconds.
2
Camera unit:
Press and hold M N for 3 seconds until the LED indicator starts
blinking.
Note:
R A message is displayed on the monitor unit to show if the registration
was successful or not, and a beep sounds.
LED indicator
You can use the LED indicator to confirm the camera unit's status.
LED indicator
Off
Green, lit
Green, blinking slowly
Green, blinking quickly
4
HNC301_(en_en)_0517_ver.120.pdf 4
1 M N (Pairing)
2 LED indicator
Status
No power
Normal operation
Registration mode
Device malfunction
2
1
2019/05/17 17:19:19
Publicité
Table des Matières
