Panasonic KX-HNC301 Manuel D'installation page 10

Wall mounting
Wall mounting
R Attach the wall mounting adaptor to the camera unit after making the
connections (page 3).
R Only use the supplied screw that is attached to the camera base when
attaching the wall mounting adaptor to the camera unit. Do not use
user supplied screws. This may cause the camera unit to become
loose from the wall mounting adaptor.
R Mount the camera unit on the stable location where the unit can be
adequately supported when installing.
R Use a string or wire to prevent the camera unit from falling and
causing injury if the camera unit comes off from the wall.
R Do not mount the wall mounting adaptor to a ceiling.
R Do not mount the camera unit on a soft material. It may fall down,
break or cause injury.
R Do not mount the camera unit on the following places: plaster board,
ALC (autoclaved lightweight cellular concrete), concrete block,
plywood less than 25 mm (1 inch) thick, etc.
1
Remove the screw and then remove the camera base from the
camera unit.
1 Supplied screw
10
HNC301_(en_en)_0517_ver.120.pdf 10
1
2019/05/17 17:19:20