Assembly - Remington BRANCH WIZARD Manuel D'utilisation Et D'entretien

ASSEMBLY

IMPORTANT: Read and understand this
manual before assembling or operat-
ing this Pole Saw. Improper use of Pole
Saw can cause severe injury. Keep this
manual for future reference.
Note: Some models are pre-assembled. Assembly
is not needed on these models.
See Saw Chain Tension Adjustment.
WARNING: Cutting edges on chain
are sharp. Use protective gloves when
handling chain.
IMPORTANT: Do not clamp Pole Saw in
vise during assembly.
1. Lay chain out flat.
2. Loosen and remove guide bar nut, sprocket
cover, and washer (see Figure 1).
3. Install guide bar onto saw body. Place center slot
of guide bar onto guide bar bolt.
4. Place chain around drive sprocket, then along
top groove of guide bar and around guide bar
nose. Note: Make sure cutting edges of chain
are facing the right direction. Position chain so
cutting edges on top of guide bar face guide bar
nose (see Figure 2 and indicator on side cover
of Pole Saw).
Guide Bar
Belleville Washer
Figure 1 - Installing Guide Bar
Towards Guide Bar Nose
Figure 2 - Chain Position
backwards. If chain is backwards, saw
will vibrate badly and will not cut.
5. Place Belleville washer, sprocket cover, and
6. Adjust saw chain tension. Follow steps under
Figure 3 - Belleville Washer Assembly
Guide Bar
Nut
Bushing
Sprocket Cover
Cutting Edge
Saw Chain
8
CAUTION: Do not place chain on saw
guide bar nut onto Pole Saw. IMPORTANT:
Make sure serrated edge of the Belleville washer
is positioned as shown in Figure 3. The serrated
edge must be in contact with the guide bar.
IMPORTANT: Tighten guide bar nut fi nger tight
only.
Saw Chain Tension Adjustment.
Serrated Edge Against
Guide Bar
Guide Bar
Belleville Washer