Measuring Cup; Important - Midea CyclonBlade MBL17HS Guide D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Control panel
6.
: Set the knob here, the machinespeed increase to high quickly, and keep high speed
for 30s, then auto stop.
7. Start/Cancel: When the machine is in the ice/snow/dessert set program run in the
process, press the Start/Cancel, the machine stops running, automatic memory program
has been running time, press the START/CANCEL button again, according to the current
gear machine continues to run, when the set time to the post, the machine stops running.
8. ON/Off: Put the jar, press the ON key, blue LED lights had flashing, the machine is in
standby mode, turn the knob to the left speed 1, 2, 3 at different speeds, or turn the knob
to the right program Ice crush; smoothie; dessert press the set program to run, or press
the PULSE key to run at maximum speed, loosen or stop. When rotated to different stalls,
its corresponding blue LED lights. Then press the OFF key machine power off state.

Measuring cup:

Insert through the lid and secure by turning clockwise. Remove the measuring cup to use
the tamper or add ingredients.
Warning
• Rotating Blades Can Cause Severe Injury.
• DO NOT reach into container while machine is running.
Blade Container:
Designed for processing liquids, including juice, frozen mixtures, sauces, soups, purees,
batters, and for wet chopping.
How to use the tamper
Warning
Rotating Blades Can Cause Severe Injury.
• DO NOT put hands, spatulas, etc. in the container while the machine is running or
while the container is still on the base.
• Lids and tampers are not interchangeable between different container styles, types,
and sizes. Use the tamper that was supplied with your machine.

Important

• The splash disk (near the top of the tamper) and lid prevent the tamper from hitting the
blades when the lid is secured properly in the locked position.
• The container should not be more than two-thirds full when the tamper is used during
blending.
• To avoid overheating during blending, DO NOT use the tamper for more than 30
consecutive seconds.
4

Publicité

Table des Matières
loading

Table des Matières