Product Description - Zelmer ODYSSEY Mode D'emploi

CAUTION!
Not observance can result in
damage to possessions
●
During work the roller of the rotating brush or suction
inlet may get obstructed with rags, papers, etc.
SUGGESTION
Information on the product and
suggestions for its use
●
Turbobrush is equipped with wheels that prevent
damage in case of unintentional use on hard floor.

Product description

Regulator
1
Connector
2
Fastening hook
3
Wheels
4
Rotating brush
5
Turbine cover
6
Assembling the turbobrush and the vacuum
cleaner
Assemble the turbobrush and the vacuum cleaner according
to instruction manual.
Using the turbobrush
To avoid obstruction of rotating element
remove big rubbish from the cleaned surface
before cleaning.
●
Switch the vacuum cleaner on.
●
Set the regulator on the turbobrush body depending on
the height of carpet hair.
Short hair carpet – move the regulator towards the
●
sign .
Long hair carpet – move the regulator towards the
●
sign .
In order to use the vacuum cleaner with the
turbobrush safely, especially while cleaning
long hair carpets and animal skins, it is
recommended to test the suction power of
the turbobrush on a small area of the cleaned
surface.
●
Slowly push the turbobrush back and forth.
18
Do not hold the working turbobrush for a longer
time in one place, but constantly move it, so as
not to damage the carpet (fitted carpet).
While cleaning carpet fringes always move the
turbobrush in the direction indicated by the
arrow (Fig.
into the rotating brush.
The speed of the brush roller rotation depends
on the amount of dust in the dust bag and
cleanliness of filters. The roller may stop
rotating on the carpet. Then the dust bag and
filters should be replaced.
Maintenance and cleaning of the turbobrush
Before cleaning and maintenance of the
G
turbobrush it must be disassembled from the
vacuum cleaner.
Cleaning of the rotating brush
During operation the brush collects pieces of:
threads, strings, hair, rags, etc. They reduce
cleaning efficiency.
To remove dirt from the rotating brush follow the steps below:
1 Place tips of scissors into the slot of the rotating brush.
2 Move the scissors so as to catch the threads and hair
tangled on the brush.
3 Cut them and take out manually or using small tongs.
Be careful not to damage the bristle of the rotating brush.
Dirt such as matches, pieces of paper or
clothing may obstruct the suction duct of the
turbobrush, leading to significant reduction of
the suction power and reduced speed or brush
roller rotation (until it completely stops).
Cleaning of the suction duct of
the turbobrush
To remove dirt from the suction duct of the turbobrush follow
the steps below:
1 Turn the turbobrush with wheels upward.
2 Press the fastening in the turbine cover and take the
cover out from the turbobrush.
3 Remove dirt from the suction duct, turbine blades and
turbine chamber.
4 Place the turbine cover so that its two ledges match
the holes in the turbobrush body, press the cover until the it
latches on the body. Characteristic clicking sound indicates
the correct assembly of the turbine cover.
). It prevents getting the fringes
H
I
J
450-020_v01