Remington HC363C Mode D'emploi page 5

Replacement combs available. Model: SP254
STEP 1 – Nape of the neck – PICTURE 1
STEP 2 – Back of the head – PICTURE 2
STEP 3 – Side of the head – PICTURE 3
STEP 4 – Top of the head – PICTURE 4
080705_REM_IFU_HC363C_22L.indd 3 080705_REM_IFU_HC363C_22L.indd 3
ENGLISH
Each comb attachment is marked accordingly on its outside middle surface. (3mm, 7mm,
9mm, 12mm, 18mm, 25mm, left and right ear guide)
INSTRUCTIONS FOR HAIR CUTTING
Note: For even cutting, allow the comb attachment/blade to cut its way through the hair.
Do not force it through quickly. If you are cutting for the first time, start with the maxi-
mum comb attachment.
Use 3mm or 7mm guide comb.
Hold the clipper with the blade teeth pointing upwards. Begin starting at the centre of the
head at the base of the neck.
Slowly lift the clipper, working upwards and outwards through the hair, trimming just a
little at a time.
With the 12mm or 18mm guide comb attached, cut the hair at the back of the head.
With the 3mm or 6mm guide comb attached, trim sideburns. Then change to the longer
9mm guide comb and continue to cut to the top of the head.
With the 18mm or 25mm guide comb attached, cut hair on top of the head against the
direction in which the hair normally grows.
For longer hair on top, use without a guide comb. Lift the hair on top of the head with a
small hand comb. Cut over the hand comb with the hair lifted or hold the hair between
the fingers to lift it and cut it to the desired length.
Always work from the back of the head.
3
03.11.2008 19:06:40 Uhr 03.11.2008 19:06:40 Uhr