Swissvoice Avena 296T Mode D'emploi page 59

Setting up the handsfree and SOS clip
The base station Avena 296T must be within range for registration (distance
between base Avena 296T and handsfree/SOS clip = less than 1 meter).
The registration must be completed within 1 minute.
• Switch on your handsfree and SOS clip before registration (ON/OFF switch set
to ON).
• Press and hold down the Paging key on the base station Avena 296T for
around 10 seconds. Release the Paging key when you hear a beep on the
base station (see user manual Avena 296T chapter "Registering additional
handsets").
• Press and hold down the volume keys + and - on your handsfree and SOS
clip for around 10 seconds until the LED flashes green and red alternately.
• When the registration was successful:
• You hear a confirmation beep on your handsfree and SOS clip and the
LED lights up green.
• The handsfree and SOS clip is assigned the next available handset num-
ber (e.g. „Handset 2").
• If registration failed, repeat the registration process.
• If you try to use your handsfree and SOS clip when it is not registered with
the base station, you will hear the message « Not registered».
Note
Your handsfree and SOS clip uses 0000 as its PIN for registration. When you have
set another PIN on your base, you must reset this to 0000 to enable registration
of the handsfree and SOS clip. After registration you can change the PIN again
(see user manual Avena 296T chapter "System PIN").
6