Stanley STHT1-7740 Mode D'emploi page 4

2.
Using your finger, pull the latch down to unlock
GB
and remove the battery door (Figure C #1).
3.
Insert two AAA batteries, making sure to position
the - and + ends of each battery as noted inside
the battery compartment (Figure C #2).
4.
Slide the pins at the bottom of the battery door
into the notches in the battery compartment
(Figure C #3), and push the door down until it
snaps into place.
When the tool is ON, the battery level appears in the
display window (Figure E #1).
Operation
1.
Point the laser at the top of the tool (Figure A
#1) toward the wall whose distance you need to
measure (Figure D #1).
2.
Click (Figure A #3) to display a laser dot on the
wall (Figure D #1) and measure the distance from
the bottom of the tool to the wall (Figure D #2).
3.
At the bottom of the display window (Figure A
#2), view the current measurement (Figure E #3),
which will keep changing as you move the tool (in
Continuous Measure mode).
4.
When the bottom of the tool is positioned at the
correct distance from the wall, click
the current measurement on the display window
(Figure E #3).
Changing the Unit of Measure
Once the current measurement is taken, you can
change the unit of measure from decimal ft (6.21 ft) to
fractional ft (6'02" ), fractional ft to meters
9/16
(1.894 m), meters to inches (74
decimal ft.
To change the unit of measurement, press and hold
until you see the measurement change (2-3 seconds).
NOTE: If you continue to hold
measurement changes, the tool will turn off.
Re-measuring
If you need to take a new measurement, click
• The previous measurement (Figure E #2) will appear
above the new current measurement (Figure E #3).
4
• When you are ready to take the new current
Turning Off the Tool
The tool can be turned off in either of these ways:
• Press and hold
• If you do not use the tool for 180 seconds, it will
to take
in), or inches to
9/16
after the
.
measurement, click .
for 4 seconds (until the display
window clears).
automatically turn off.