BAC VCL 208-N R Manuel Technique page 32

General Instructions:
- Always follow applicable site Health and Safety instructions.
- Install relevant safety warning signs/padlocks to alert people of the works taking place.
- Follow product safety data sheets and product information.
- Electrically shut down and drain the unit.
- Use personal protection equipment as prescribed.
 Perform this step after "the rigging and installation" and before "the start – up" of
the unit!
Removing of the white protective sac:
1. After the rigging and installation of the unit, the white protective sac must be removed
from the float ball.
Tip:
If you loosen or cut the straps of the sac, you can remove the white protective sac
from the float ball.
METHOD STATEMENT 17C133
Removing white protective sac around float ball
DATED : 22 March, 2017
Created by DIDE
1/1