Ego Power+ PH1400 Guide D'utilisation page 97

1. Stop the motor and remove the battery pack.
2. Adjust the blade to the horizontal position, ensuring that the blade assembly is in
line with the hedge trimmer shaft for easy mounting (Fig. 14).
3. Use a 4mm hex wrench (not included) to loosen the 6 screws (short screws) in
the bottom cover and remove them.
4. Continue loosening the 2 screws (long screws) to remove the support plate 1 & 2,
as well as the 2 bushings. The 2 bushings are separately located inside the two
rounded rectangle slots in the blade assembly.
5. Remove the support plate 3.
6. Carefully remove the link lever from the blade.
7. Remove the blade assembly from the tool and replace it with a new one.
8. Align the inward bulge on the new blade assembly with the hole inside the
eccentric block assembly to install the new blade assembly into place.
9. Insert the two bushings into the two rounded rectangle separately.
10. Mount the support plate 1 and then mount the support plate 2.
11. Keep the inside holes in the blade, the bushings, and the holes in the support
plates in line with the screw holes in the gear case. Install the 2 long screws into
the aligned holes and tighten them securely (Fig.15).
15
Long Screw
Support Plate 2
Support Plate 1
Inward Bulge
Outward Bulge
Bushing
Rounded Rectangle Slots
Screw Holes in the Gear Case
Hole inside the Eccentric Block Assembly
HEDGE TRIMMER ATTACHMENT—HTA2000
25