Series
REAR PANEL
1
2
1 "DC 12-18V" POWER SOCKET
Connect to this socket the supplied adapter only.
2 UNBAL
Unbalanced audio output with 6,35mm (1/4") jack. Connect this output into an
unbalanced input of your mixer.
3 AF OUTPUT
Balanced audio output with XLR-M socket. Connect this output into a balanced
input of your mixer.
2.2 | HANDHELD WIRELESS MICROPHONE - START 8M
1
6
2
3
1 GRILLE
It protects the microphone capsule from impacts and/or accidental falls and it
reduces the noise of the plosive.
2 POWER ON AND BATTERY STATUS INDICATOR
GREEN: Transmitter activated (ON), charged batteries.
RED: Immediately replace the batteries.
WARNING: battery life is about 10 hours, but it may vary according to the usage
conditions.
START 8 Series
6
User manual |
3
4
5
3 ON/OFF
Press this button for 3" to turn on or off the wireless handheld microphone.
4 BATTERIES COMPARTMENT
To access the battery compartment unscrew the lid counterclockwise,
and screw the lid clockwise to close it.
Remove the batteries from the receiver when not in use for extended
periods.
5 IR WINDOW
It allows the synchronization of the channel (frequency) with the receiver.
After choosing the desired channel, press the ASC button, place the
bottom of the wireless microphone close to the IR window of START 8R
receiver and wait for the selected channel to stop flashing on the handheld
display. After the synchronization, the receiver's display is lit steadily on
the selected channel (frequency).
6 ANTENNA
The antenna is integrated into the transmitter. For a proper functioning,
hold the microphone in the central part.
2.3 | BELTPACK TRANSMITTER - START 8B
1
1 ANTENNA
3
2
7
4
5
6
2 ON/OFF
3 IR WINDOW
It allows the transmission of
the signal.
Press this button for 3" to turn on
or off the beltpack transmitter.
ATTENTION: The transmitter
and the receiver must be set
on the same channel of the
same band.
It allows the synchronization
of the channel (frequency) with
the receiver.
START 8 Series
| User manual
7