Urmet 1098/800 Guide Rapide page 12

EN
Control and configuration via
monitor or TV
If you have chosen to use the kit by connecting a monitor or colour TV with next-generation HDMI port to the NVR,
you can use the NVR menu to configure the system and view the images. You can interact with the system using
the remote control or the mouse, both included.
Control and configuration via PC
By connecting the NVR to your home LAN using an Ethernet 10/100 Mbps cable (not included) connected to the
RJ45 port you can control the system from PC or remotely, if the LAN is connected to the Internet.
After having configured NVR and cameras on the network, the NVR can be connected using the Internet browser
of the PC. The PC workstation must be connected to the LAN to which the NVR is connected.
Install the "Device Search" software on the CD supplied with the product on a PC with Windows operating
system connected to the same network as the NVR to connect the NVR. At the end of installation, run the
software which detects NVR on the LAN and located it on the list. At this point, click on the IP address of the
NVR shown on the list.
For more information, see the instruction manual of the NVR.
It is also possible to connect to one or more NVR at the same time using the URMET UVS client software,
available on the CD provided with the product.
For more information, see the instruction manual of the NVR.
12
DS1098-002B