Setting To Work - Connection To The Power Supply; Extensions; Dry Applications; Maintenance And Repairs - Blastrac BDC-133M Manuel D'instructions

Operating manual BDC-133M / BDC-133H
Setting to work - connection to the
power supply
WARNING!
The vacuum cleaner filtering column has two
positions:
1 - UP position for "Operation"
2 - DOWN position for "Transport"
Always use the vacuum cleaner in "Operation"
position.
WARNING!
Make sure there is no evident sign of damage to
■
the vacuum cleaner before starting work.
■ Before plugging the vacuum cleaner into the
electrical mains, make sure the voltage rating
indicated on the data plate corresponds to that
of the electrical mains.
Connect the plug into a socket with a correctly
■
installed ground contact/connection.
■ Make sure that the vacuum cleaner is turned off.
The plugs and connectors of the connection
■
cables must be protected against splashes of
water.
Make sure that connections to the electrical
■
mains and plug are correct.
■ Use the vacuum cleaners only when the cables
that connect to the electricity mains are in
perfect condition (damaged cables could lead to
electric shocks!).
Regularly check there are no signs of damage,
■
excessive wear, cracks or ageing on the electric
cable.
WARNING!
When the device is operating, do not:
■ Crush, pull, damage or tread on the cable that
connects to the electrical mains.
Only disconnect the cable from the electrical
■
mains by removing the plug (do not pull the
cable).
Only replace the electric power cable with one
■
of the same type as the original: H07 RN - F. The
same rule applies if an extension is used.
■ The cable must be replaced
by the manufacturer's Service
Centre staff or by equivalent
qualified personnel.

Extensions

If an extension cable is used, make sure it is suitable for the
power input and protection degree of the vacuum cleaner.
Minimum section of extension cables: 2.5 mm
Maximum length = 20 m
Cable = H07 RN - F
WARNING!
Sockets, plugs, connectors and installation of the
extension cable must maintain the IP protection
degree of the vacuum cleaner, as indicated on the
data plate.
WARNING!
Never spray water on the vacuum cleaner: this
could be dangerous for persons and could short
circuit the power supply.
WARNING!
The vacuum cleaner's power socket must be
protected by a differential circuit-breaker with
surge current limitation, that shuts off the power
supply when the current discharged to the ground
exceeds 30 mA for 30 msec. or an equivalent
protection circuit.

Dry applications

[ NOTE ]
The supplied filters and the dust bag must be installed
correctly.
WARNING!
Comply with the safety regulations governing the
vacuumed materials.

Maintenance and repairs

WARNING!
Disconnect the vacuum cleaner
from its power source before
cleaning, servicing, replacing
parts or converting it to another
version/variant, the plug must be
disconnected from the socket.
Carry out only the maintenance operations
■
described in this manual.
■ Use only original spare parts.
Do not modify the vacuum cleaner in any way.
■
Failure to comply with these instructions could
jeopardize your safety. Moreover, such action would
immediately make the EC declaration of conformity
issued with the vacuum cleaner void.
www.blastrac.eu ‒ info@blastrac.eu
5/18
2
GB