Paradox Security Systems Grafica DNE-K07 Mode D'emploi page 6

3.2 Keypad Cover Clearance
Grafica's keypad cover requires sufficient space in order to open properly.
Ensure a clearance of approximately 9cm (3.5in) between the bottom of the
keypad and possible obstructions such as a light switch that may prevent
the keypad from opening properly (Figure 2 on page 35).
3.3 Mounting the Metal Wall Plate
1. Place metal wall plate to desired position.
2. Drill and insert screws into holes labeled "A" (Figure 4 on page 36). Both
the top and bottom center holes "C" can be used for an electrical box.
3.4 Connecting Grafica
You can connect Grafica to the control panel's combus in a star and/or daisy
chain configuration. The combus consists of four wires that provide power
and two-way communication between the control panel and all modules
connected to it. Connect the four terminals labelled
of the module to the corresponding terminals on the control panel (Figure
5 on page 37). Please refer to the appropriate control panel's Reference &
Installation Manual for maximum allowable installation distances.
3.5 Keypad Input
Grafica's keypad input can be utilized as a zone input or as an input for the
optional temperature sensor (section 2.3.2 on page 3). Refer to Figure 5 on
page 37 for connection instructions.
3.6 Mounting Grafica
1. Place Grafica's back plate flush against the mounted metal wall plate "B"
(Figure 7 on page 38).
2. Slide Grafica's open slots labeled "A" (Figure 6 on page 38) onto the
metal wall plate's tabs labeled "A" (Figure 7 on page 38).
3. Gently apply downward pressure to snap Grafica onto the metal wall plate.
4. You may insert the optional screw "C" under the Grafica keypad through
the space in the metal wall plate's left tab (Figure 7 on page 38).
3.7 Removing Grafica
1. If required, remove the optional screw (Figure 7 on page 38).
2. Gently lift the unit upwards with your hands until it separates from the
metal wall plate (Figure 8 on page 39).
4 Reference & Installation Manual
, , and
RED BLK GRN YEL