Temperature Calibration; Uploading/Downloading Data And Updating - Paradox Security Systems Grafica DNE-K07 Mode D'emploi

5.10 Confidential Mode Timer
S [004]
ECTION
Section [004] determines the amount of time that must elapse without
performing an action on the keypad before the keypad enters Confidential
Mode (section 5.5 on page 7). The Confidential Mode Timer can be any
value from 005 to 255 seconds (default: 120 seconds).

5.11 Temperature Calibration

S [005] = O
ECTION
S [006] = I
ECTION
The outside temperature reading is that given by the optional external
temperature sensor (section 2.3.2 on page 3) when connected to Grafica's
input. The inside temperature reading is that given by Grafica's built-in
temperature sensor (section 2.3.1 on page 3). If the temperature reading is
inaccurate, enter a calibration value in the corresponding section to adjust
the reading. Enter a value between 000 to 254 (000 and 128 = no
calibration value). When in Celsius, every value from 001 to 127 adds .5
degrees, and every value from 129 to 254 subtracts .5 degrees, to the
temperature display. When in Fahrenheit, every value from 001 to 127 adds
1 degree, and every value from 129 to 254 subtracts 1 degree, to the
temperature display.

6.0 Uploading/Downloading Data and Updating

6.1 Download Data from the Memory Key
S [100]
ECTION
Use this section to download Grafica sections [001] to [004], all zone labels,
area labels and user labels from the Memory Key.
Only the Memory Key will function with Grafica keypads.
1. Insert the Memory Key into the keypad's connector (Figure 9 on
page 39).
2. To download the contents of the Memory Key, enter the keypad's
programming mode (section 4.1 on page 5) and enter section [100] in
step 5.
3. When the keypad emits a confirmation beep, wait five seconds and
remove the Memory Key after the second confirmation beep.
6.2 Copy Data to Memory Key
S [110]
ECTION
T
UTSIDE EMPERATURE
T
NSIDE EMPERATURE
C
ALIBRATION
C
ALIBRATION
Reference & Installation Manual 9