Like It PRO600 Instructions De Montage Et D'utilisation page 45

5.2.5- The door will open and close automatically to map the open and close sensitivity
force requirements.
5.2.6- It displays " I I " to show setting is complete.
that the setting position wasn't saved. See the possible solution in Chapter 6
"Troubleshooting".
5.2.7- After programming the limit switch, open the door to the fully open position, and then adjust and
tighten the rear mechanical stop (A) against the carriage (B) shown in figure 4.
B
LIKE IT
A
Fig 3.
Fig 1.
Fig 2.
If you see the symbol " - " it means
B
B
A
A
Fig 4.
EN
44