B Ase Station; Back View - Snom m9 Guide Rapide

E
snom m9 Quick Start Guide
N
G
i
L
nstallation
I
Before first use, the handset battery should be charged
S
H
fully. This will take approximately 8 hours.
p
reparation of handset
1. Lift off the battery cover.
2. Insert the battery pack with the electrodes in the top left corner.
Replace the cover.
3. Connect the 5.9 V power supply of the charger to the wall outlet
first, then to the charger, and place the handset in the charger.
1.
B
ase station
Registration LED
– lit when the base
station is registered
Network LED
– flashes during boot,
indicating that the base
station has received an IP
address
Power LED
– lit when on
14
2. 3.
Call LED
– flashes during firmware update
– lit when call in progress
– blinks slowly when waiting for
handset registrations
1. When the handset is ready for use, connect one end of the network
cable with the NET port on the back of the base station and the
other end to a LAN port in your network (switch, router, etc.).
2. Connect the 5 V power converter to the wall outlet first, THEN to
the base station.
Reset
button
RESET 5V 5V DC DC
Power
connector
3. The power indicator comes on and the base station begins to boot.
4. When the base station has booted up, the "Call" LED will start
to blink, indicating that the base station is waiting for handset
registration.
h
andset oVerVieW
Side view
Belt clip
Volume adjust key+-
Adjust volume
• of ringer when call is ringing
• of speaker when in call
Speakerphone key (on/off)
Headset jack connector 2.5 mm
Loudspeaker

Back view

of
speakerphone
snom m9 Quick Start Guide
NET NET
Net port
Battery cover
15
E
N
G
L
I
S
H