Firesense 1031510 Mode D'emploi page 9

ASSEMBlY
9
While supporting heater, tilt the Head Assembly
and slide 3 large Flat Washers
Studs W . Place the reflector assembly onto the Reflector Studs
and slide 3 large Flat Washers over the Reflector Studs and
onto the Reflector Assembly. Secure with 3 Wing Nuts.
Once you have tightened the Wing Nuts, return the heater
to an upright position.
Hardware Used: 6x Large Flat Washer
10
Connect the hose and regulator to the LP cylinder.
The LP cylinder is sold separately. Use a standard
9.07 kg / 20 lb propane cylinder only. Lift the Tank Housing
up and rest it on the top of the assembled Post Supports
Screw Regulator H onto Gas Hose
Hand tighten securely then tighten with the Wrench. Attach
the Regulator to the valve on the LP cylinder and hand tighten
securely. Place LP tank onto base of heater. Secure the
LPG tank by attaching the Chain
Lower the Tank Housing.
NOTE: Use this heater only with a propane vapor withdrawal
supply system. See chapter 5 of the standard for storage and
handling of liquefied petroleum gas, ANSI/NFPA 58. Your local
library or fire department should have this book.
Contact us for assistance: (866) 985-7877 | www.wtliving.com
R over the Reflector
B
3x Wing Nut V
E . Do not cross thread.
onto the post supports.
L
C
D
I .
9