Preparation - Firesense 1031510 Mode D'emploi

ASSEMBlY

PREPARATION

Before beginning assembly of this appliance, make sure all parts are present. Compare all parts with package contents list
and hardware contents as listed on page 4 of this manual. If any part is missing or damaged, do not attempt to assemble
this product. Contact customer service for replacement parts.
ESTIMATED ASSEMBlY TIME: 60 minutes
Tools Required for Assembly (NOT included):
• 7/16" open-end wrench
• Adjustable wrench
Note: This heater has an Electronic Ignition and will require installation of 1 – AAA battery. The battery should be installed
by unscrewing the RED IGNITER BUTTON – battery not included.
The Waterbox will be pre-assembled to the base. To fill, pull
open the plastic cap on top of the waterbox and fill with water
or sand. Place the plastic cap back on top. You may find it
easier to fill the waterbox prior to attaching wheels.
1
Attach Wheel Assembly
Base, and insert 2 Small Bolts
finger tighten. Be sure that the Wheel Assembly is parallel to
the Base J and tighten with the Wrench
Hardware Used: 2x Small Bolts
2
Attach the Post Supports
in the bottom of each Post Support with the hole on the
Base. Insert 1 Small Bolt
N
into the Base and hand tighten. Repeat with the other 2 Post
Supports and then tighten all bolts with the Wrench
Hardware Used: 3x Small Bolts
Contact us for assistance: (866) 985-7877 | www.wtliving.com
• Phillips screwdriver w/medium blade
• Leak test solution (see page 10)
K to Base J . Align holes to the
N through the holes and
X .
N
I to the Base J . Align the holes
through the hole in the support and
X
N
Base
.
Waterbox Cap
6