Firesense 1031510 Mode D'emploi page 7

ASSEMBlY
3
Attach the lower Post
you have tightened the bolts holding the Post Supports
to the Base J , align the holes in the lower Post
holes on the tops of the Post Supports and insert a large
Bolt M through the hole in the Post Support. Secure with
a Small Flange Nut . Repeat this in the 5 remaining holes
S
(6 holes total—2 for each Post Support piece). Hand tighten
initially then tighten with the Wrench
been inserted.
Hardware Used: 6x Large Bolt
4
Attach Upper Post F
two pieces of the post together.
Note: Bolts not needed to hold the posts in place.
5
Slide Tank Housing
D
Posts / and down over the Post Supports
F G
Tank Housing on the Base
6
Attach Reflector Studs to the top of the Head
Assembly . Insert 1 Reflector Stud through 1 large Flat
C
Washer and into the hole on the top of the Head Assembly
Tighten stud securely. Repeat with the other 2 Reflector Studs.
Hardware Used: 3x Reflector Stud
Contact us for assistance: (866) 985-7877 | www.wtliving.com
G to the Post Supports I
G with the
X when all bolts have
M
6x Small Flange Nut S
to lower Post G by screwing the
over the assembled Upper/lower
I
J .
W
3x Large Flat Washer R
. Once
I
. Rest the
.
C
7