Press the Auto Button. (Auto Adjust)
3
Adjust the image manually by following procedure below when the screen has a
4
flicker or blur, or the picture does not fit in the display area after performing the Auto
Adjust.
Adjust the V.Position so that the top and bottom of the picture frame will fit to the
5
display area.
1) Adjust the H.Position so that the left side of the picture frame will move to the left
6
edge of the display area.
2) Stretch the right side of the picture frame to the right edge of the display area by
adjusting the Pixel Clock.
NOTE
NOTE
When the left side of the picture frame moves apart from the left edge of the display
area during the Pixel Clock adjustment, adjust steps 1) and 2).
Another way to make the Pixel Clock adjustment is to correct the vertical wavy lines
in the zebra pattern.
The picture may flicker during the Pixel Clock, H.Position and V.Position adjustment.
In case the picture frame is bigger or smaller than the data display area after the Pixel
Clock adjustment, repeat steps from .
PLE2200WS-e-M015A01.P65
19
OPERATING THE MONITOR
9/7/2006, 8:56 PM
1
15