Computer Setting; Adjusting The Viewing Angle - Iiyama ProLite E2200WS Mode D'emploi

COMPUTER SETTING

Signal Timing
Change to the desired signal timing listed on page 21: COMPLIANT TIMING.
Windows 95/98/2000/Me/XP Plug & Play
The iiyama LCD monitor complies with DDC2B of VESA standard. The Plug & Play function runs on
Windows 95/98/2000/Me/XP by connecting the monitor to DDC2B compliant computer with the
Signal Cable supplied.
For installation on Windows 95/98/2000/Me/XP: The monitor Information File for iiyama monitors
may be necessary for your computer and obtained via the Internet, using the address:
NOTE For additional information on how to download the driver for your touch screen monitor,
please access the internet site noted above.
Monitor Drivers are not required in most cases for Macintosh or Unix operating systems.
For further information, please contact your computer dealer first for advice.

ADJUSTING THE VIEWING ANGLE

For optimal viewing it is recommended to look at the full face
of the monitor.
Hold the stand so that the monitor does not topple when you
change the monitor's angle.
You are able to adjust the monitor's angle up to 5 degrees
forward, 20 degrees backward.
In order to ensure a healthy and relaxed body position when
using the monitor at visual display workstations, it is
recommended that the adjusted tilt angle should not exceed
10 degrees. Adjust the monitor's angle to your own preference.
NOTE
NOTE
NOTE Do not touch the LCD screen when you change the
angle. It may cause damage or break the LCD screen.
Careful attention is required not to catch your fingers
or hands when you change the angle.
Do not tilt the post beyond 20 degrees except when
repacking the monitor in its box.
To do so may cause the monitor to fall over and break.
8 BEFORE YOU OPERATE THE MONITOR
PLE2200WS-e-M015A01.P65
http://www.iiyama.com
12 9/7/2006, 8:56 PM