Operating The Dryer - LG DLEX2450 Série Mode D'emploi

OPERATING THE DRYER

CLEAN THE LINT FILTER
1
If the lint filter has not already been cleaned, lift out
the filter and remove the lint from the last load. This
will help ensure the fastest and most efficient drying
performance.
2 LOAD THE DRYER
Load the dryer with the wet laundry from the washer.
If the load is extra large, you may need to divide it into
smaller loads for proper performance and fabric care.
3 TURN ON THE DRYER
Press the POWER button to turn on the dryer. The cycle
LEDs will illuminate and a beep will sound, if turned on.
Refer to page 27.
SELECT A CYCLE
4
Turn the cycle selector knob either direction until the
LED for the desired cycle is on. The preset temperature,
dry level, and option settings for that cycle will be
shown. Refer to page 29.
SELECT CYCLE MODIFIERS
5
Default settings for the selected cycle can now be
changed if desired. This can be done using the cycle
modifier buttons as shown on page 32.
NOTE: Not all options or modifiers are available on all
cycles. A different chime will sound and the LED will not
come on if the selection is not allowed.
SELECT CYCLE OPTIONS
6
Cycle options can be added using the option buttons as
shown on page 32-33.
NOTE: Not all options or modifiers are available on all
cycles. A different chime will sound and the LED.
BEGIN CYCLE
7
Press the START/PAUSE button to begin the cycle. The
cycle can be paused at any time either by opening the
door or by pressing the START/PAUSE button. If the
cycle is not restarted within 4 minutes, the dryer will
shut off and the cycle settings will be lost.
END OF CYCLE
8
When the cycle is finished, the chime will sound if it is
set. Remove your clothing from the dryer immediately
to reduce wrinkling. If wrinkle care is selected, the dryer
will tumble briefly every few minutes to help prevent
wrinkles from setting in the clothes.
29