Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
File Type : WMA10 Pro
[Bit rate] ~ 768 Kbps
[Channel / Sample freq.]
M0 : up to 2 Channel @ 48 kHz
(Except LBR mode),
M1 : up to 5.1 Channel @ 48 kHz,
M2 : up to 5.1 Channel @ 96 kHz
[Support] WMA10 Pro
File Type : OGG
[Bit rate] Free Format
[Sample freq.] ~ 48 kHz
[Support] OGG Vorvis
Supported Photo Formats
Category : 2D (jpeg, jpg, jpe), 3D (jps)
[Available le type] SOF0: Baseline,
SOF1 : Extend Sequential,
SOF2 : Progressive
[Photo size] Minimum : 64 x 64,
Maximum : Normal Type: 15360 (W) x 8640 (H),
Progressive Type : 1920 (W) x 1440 (H)
Category : BMP
[Photo size] Minimum : 64 x 64, Maximum : 9600 x 6400
Category : PNG
[Available le type] Interlace, Non-Interlace
[Photo size] Minimum : 64 x 64, Maximum : Interlace : 1200 x 800,
Non-Interlace : 9600 x 6400
Category : MPO (3D)
[Photo size] 4:3 Size : 3648 x 2736 / 2592 x 1944 / 2048 x 1536, 3:2
Size : 3648 x 2432
BMP and PNG format les may be slower to display than JPEG.
The 3D function may di er depending on the model.
To see web manual
To obtain detailed User Guide information, please visit www.lg.com.
External control device
setup
To obtain the external control device setup information, please visit
www.lg.com.
Troubleshooting
Cannot control the TV with the remote control.
Check the remote control sensor on the product and try again.
Check if there is any obstacle between the product and the remote
control.
Check if the batteries are still working and properly installed (
to ,
to ).
No image display and no sound is produced.
Check if the product is turned on.
Check if the power cord is connected to a wall outlet.
Check if there is a problem in the wall outlet by connecting other
products.
The TV turns o suddenly.
Check the power control settings. The power supply may be
interrupted.
Check if the
Automatic Standby
(Depending on model) /
Timer
/
Off Time
is activated in the
If there is no signal while the TV is on, the TV will turn o
automatically after 15 minutes of inactivity.
When connecting to the PC (HDMI), 'No signal' or 'Invalid Format' is
displayed.
Turn the TV o /on using the remote control.
Reconnect the HDMI cable.
Restart the PC with the TV on.
Sleep
TIME
settings.
21
Publicité
Table des Matières
