Cartridge Kit Preparation - TECHCON SYSTEMS TS6500CIM Manuel D'utilisation

5. The desired air pressure will be displayed on the screen.
6. Turn on the unit by pressing the power button (Fig. 4). The cartridge holder
should move up to home position. If it does not move up, please check
pressure connection.
8.5

Cartridge Kit Preparation

Injection Kit:
The TS6500 Mixer has an automatic injection device that will inject the hardener
into the catalyst before the mixing cycle starts. However, the valve in the mix rod
needs to be opened before placing the kit in the machine. Follow the below
instructions to open the valve.
1. Insert the ram rod into the mix rod.
2. Push the ram rod to force the valve open.
3. Follow the instructions in section 8.7 to mix the injection kit.
MIX ROD
Barrier Kit
1. Remove barrier tape from the kit.
2. Pull the mix rod down to the fullest extend to remove the foil from the
dasher.
3. Follow instructions in section 8.7 to mix the barrier kit
MIX ROD
Figure 10.0 Injection Kit
DASHER
Figure 11.0 Barrier Kit
14
VALVE
BARRIER TAPE
FOIL