Technical Specifications; Before Use - Omcan MG-CN-0010 Manuel D'instructions

Safety and Warranty
without difficulty.
In any case, for suitable recycling, we suggest disposing of the products separately (differentiated
waste) according to the current norms.
DO NOT DISCARD ANY PACKAGING MATERIALS IN THE ENVIRONMENT!

Technical Specifications

Model
Power
Electrical
Plate Size
Spout Size
Throat Opening
Dimensions
Item #
Operation

BEFORE USE

• Make sure that the voltage and frequency indicated on the rating plate are the same as your local supply.
• Wash all the parts (except those that do not touch food products) in warm soapy water.
• Before plugging in, ensure the switch is off.
TO MINCE MEAT
1. Place the head tightly onto opening of motor housing. While holding the head with one hand, place the
locking knob into the hole on the side of motor housing and tighten it clockwise.
2. Place the worm into the head, long end first, then turn the worm slightly until it is set into the motor housing.
3. Place the cutting blade onto the worm with the blade facing the front.
▪ If it is not fitted properly, meat will not be ground.
4. Place the desired cutting plate next to the cutting blade, fitting the protrusions on the housing in the slots on
the plate.
5. Screw the cap into place until tight, tighten by hand only.
▪ Do not over tighten.
MG-CN-0010
0.5 HP / 372.8 W
110V / 60Hz / 1
0.2", 0.3", 0.4" / 5mm, 8mm, 10mm
0.5", 0.7", 0.8" / 12mm, 17mm, 20mm
2" / 51mm
16.25" x 8" x 17.5" / 413 x 203 x 445mm
21640
6