TP-Link RE200 Guide Rapide page 3

LEDs
5G and 2.4G
Red: The extender is connected
to the 2.4GHz/5GHz wireless
network of the router, but is too
away from it.
Green: The extender is
connected to the 2.4GHz/5GHz
wireless network of the router
and is in a good location.
Off: The extender isn't
connected to the router.
(Wireless Signal)
On: The wireless function is
enabled.
Off: The wireless function is
disabled.
(Ethernet)
On: A device is connected the
Ethernet port, but there is no
activity.
Flashing: A device is connected
to the Ethernet port, and is
active.
Off: No device is connected to
the Ethernet port.
Two easy setup options:
ONE: Using a Web Browser
TWO: Using WPS(Wi-Fi Protected Setup)
(Power)
On: The exxtender is on.
Off: The extender is off.
(RE)
On: WPS connection is established.
Blinking: WPS connection is in
process.
Off: No active connection .
RESET: Press this button to reset
the extender to its factory defaults.
Ethernet port: Connect your
Ethernet-enabled device to this
port to enjoy the Internet.
1
English
Reset
Ethernet port