Security Setup - UMX MXC-570 Mode D'emploi

• Blacklist: You can set up a blacklist. After enabling the blacklist, the phone numbers listed in the blacklist
will not be able to call this phone.
o Status: Disable/Enable.
o B lacklist List: Up to nine blacklisted entries can be added. You can edit the list through this menu.

Security Setup

To make changes in the Security menu, you must correctly input the phone password. The initial password is
1234.
• Phone Lock: If "Enabled", when the phone is powered on you will be prompted to enter the phone's
password correctly to use the phone.
• Keypad Lock: The keypad lock can be set to be enabled after 5 seconds, 30 seconds, 60 seconds, or
5 minutes. To unlock the keypad, press "*" then the Answer/Send key. Even when locked, you may
answer an incoming call.
• Call History Lock: If enabled the phone will require the password to be entered each time you access the
phone's Call History.
• P honebook Lock: If enabled, the phonebook cannot be viewed until the password is entered.
• Message Lock: If enabled, the phone will require the password to be entered to access messages.
• Change Password: Change the password using this option. The Old Password must be entered before a
new one is accepted. Enter the same new password twice and press the left soft/menu key to confirm.
The new password will then become effective. During this course you may press the right soft key to
discard the change at any time and return to higher-level menu. You can create separate passwords for
the phone lock, the call history lock, the phonebook lock, and the message lock.
• Restore Factory Settings: This function is used for restoring to the default factory settings.
38