Replacing The Power Cable; Switching On/Off; Technical Data - Kawasaki S&S POWERSTORE K-BS 900 Traduction De La Notice Originale

drive rollers.
GB
• Ensure that the direction of the sanding/
grinding belt (arrows on the inside of the
sanding/grinding belt) is identical to the direction
of the belt sander/grinder (arrow over the rear
drive roller).
• Press the clamping lever (10) to the rear to
tension the sanding/grinding belt.
7.3 Adjusting the position of the belt
(Fig. 6/Item 7)
• Hold the belt sander/grinder with the
sanding/grinding plate at the top.
• Switch on the belt sander/grinder.
• By turning the setting screw (7) the belt position
should be set so that the sanding/grinding belt is
at the center of the two drive rollers.
8. Starting up

8.1 Switching ON/OFF

To switch on:
Press the ON/OFF switch (5).
Continuous operation:
Secure the switch (5) with the locking button (4).
To switch off:
Press the ON/OFF switch (5) briefly.
The machine can be operated on a temporary
or permanent setting.
8.2 Setting the belt speed (Fig. 7/Item 3)
You can select the belt speed by turning the
setting knob (3).
PLUS direction:
Increase belt speed
MINUS direction:
Reduce belt speed
8.3 Instructions for use
Important. Never hold the workpiece you wish to
sand/grind in your hands. Secure the workpiece
on a sturdy surface or using a vise.
• Allow the belt sander/grinder to start before you
place it on the workpiece.
• Do not switch off the belt sander/grinder as long
as the sanding/grinding belt is in contact with the
workpiece.
• Always hold the belt sander/grinder with both
hands whilst it is in use.
• Always sand wood in the direction of the grain.

9. Replacing the power cable

If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
aftersales service or similarly trained personnel to
avoid danger.

10. Technical data

Mains voltage:
Power input:
Belt speed:
Sanding/Grinding belt size:
Protection class:
Weight:
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L : sound pressure level 93,4 dB(A)
pA
K : uncertainty 3 dB(A)
pA
L : sound power level 104,4 dB(A)
WA
K : uncertainty 3 dB(A)
WA
14
230-240 V~/ 50 Hz
810 W
200-380 m/min
533 x 76 mm
II /
3,8 kg