Jtpm1: Tpm Module Connector; Jci1: Chassis Intrusion Connector - MSI H110M PRO-VD Mode D'emploi

JTPM1: TPM Module Connector

This connector is for TPM (Trusted Platform Module). Please refer to the TPM
security platform manual for more details and usages.
2
1

JCI1: Chassis Intrusion Connector

This connector allows you to connect the chassis intrusion switch cable.
Using chassis intrusion detector
1. Connect the JCI1 connector to the chassis intrusion switch/ sensor on the
chassis.
2. Close the chassis cover.
3. Go to BIOS > Security > Chassis Intrusion Configuration.
4. Set Chassis Intrusion to Enabled.
5. Press F10 to save and exit and then press the Enter key to select Yes.
6. Once the chassis cover is opened again, a warning message will be displayed on
screen when the computer is turned on.
Resetting the chassis intrusion warning
1. Go to BIOS > Security > Chassis Intrusion Configuration.
2. Set Chassis Intrusion to Reset.
3. Press F10 to save and exit and then press the Enter key to select Yes.
14
Overview of Components
1
3
5 LPC address & data pin0
14
7 LPC address & data pin1
13
9 LPC address & data pin2
11 LPC address & data pin3
13
Normal
(default)
LPC Clock
LPC Reset
LPC Frame
Trigger the chassis
intrusion event
2 3V Standby power
4 3.3V Power
6 Serial IRQ
8 5V Power
10 No Pin
12 Ground
14 Ground