Maintenance; Nozzle; Brushes - Hoover MAX Extract DUAL V Guide D'utilisation

Familiarize yourself with these home maintenance tasks as proper use and care of your cleaner will ensure
continued cleaning effectiveness.
Any other servicing should be done by an authorized service representative.

nozzle:

how to Clean
If lint or other debris becomes lodged in nozzle, it
can be removed for cleaning.
CAUTION
!
To reduce the risk of injury from moving parts,
unplug cleaner before servicing.
Remove both tanks as described in Fig. 2.16. With
handle in upright position, tilt cleaner back so that
handle rests on the floor.
5.1 Lift up rear edge of nozzle. Slide nozzle up and
remove from cleaner.
5.2 To replace nozzle, line up tabs (A) on nozzle
with holes (B) in cleaner. Slide tabs into holes.

brushes:

how to Change and Clean
Your cleaner is equipped with removable brushes.
Follow these directions for changing brush
assemblies or for easy cleaning.
CAUTION
!
To reduce the risk of injury from moving parts,
unplug cleaner before servicing.
how to remove
To prevent possible leaking, remove Clean Water
Tank and Dirty Water Tank. Set tanks aside.
With handle in upright position, tilt cleaner back until
handle rests on the floor.
5.3 Grab brush assembly and pull firmly.
The brushes can be cleaned under running water.
how to replace
5.4 Align posts (A) on both ends of brush assembly
with slots (B) in cleaner housing.
Make sure that the square post (C) also aligns with
the square hole (D). Turn brushes slightly until post
fits easily into hole.
Press brush assembly firmly to snap into place.

5. MaintenanCe

5.1
!
Slide nozzle completely onto cleaner. Press down
on nozzle to secure it.
Replace Dirty Water Tank (Fig. 2.16).
The nozzle must be in the proper position in order
for the Dirty Water Tank to go on properly.
5.3
!
5.4
17
b
A
C
Actual model may vary from images shown.
5.2
b
A
D
b
A