Evercraft 776-3758 Guide D'utilisation page 6

Proper han d ling of the gun is essential for ob t ain i ng a good finish.
The gun should be held at a right angle to the sur f ace being cov e red,
and moved par a l l el with it. For precise con t rol of the gun and
material, the trigger should be re l eased before the end of the stroke.
Hold the gun from 6 to 12 inches away from the surface depending
on ma t e r i a l and at o m i z i ng pres s ure. For a uniform finish, lap each
6 to 12 inches
Start
Pull
stroke
trig ger
RIGHT
Air CAp TEsT KiT – usE ANd purpOsE
For maximum transfer efficiency, do not use more air pressure than is necessary to atomize the material being applied.
1. Install the air pressure gauge at the gun handle and replace the air cap with the Air Cap Test kit (RSTK58 sold separately)
2. When the spray gun is triggered on, adjust the incoming air pressure to the desired setting 36-43 psig in order to provide a
maximum of 10 psig at the air cap .
The air cap air pressure cannot exceed 10 psig in order to be in compliance with EPA and SCAQMD regulations"
776-3758
OpErATiON
Even and wet coat
Release End of
trigger Stroke
RSTK58 Air cap test kit only fits Model 776-3758
stroke over the pre c ed i ng stroke, making sure the spray is smooth
and wet.
Using the lowest possible atomizing air pres s ure will reduce
overspray and provide max i m um ef f i c ien c y.
Light Coat
WRONG
6
Heavy Coat
Rev. 07/21/14