Evercraft 776-3758 Guide D'utilisation page 5

• Tighten the gun to the cup securely with the nut and fitting supplied.
• Be sure to have the proper air pres s ure at the gun to operate. Proper air pres s ure for this tool should not exceed 36 psig for lacquer
and 43 psig for enamel.
• Adjust fluid control screw and spray width adjustment screw to your desired pattern before using on pro d uc t ion.
• Clean all parts after use.
HVLP SPRAY GUN
The model you have purchased is a professional
high volume, low pressure spray gun. It is designed
to spray very efficiently with virtually no overspray.
To accomplish this, the inlet pressure regulation
is critical. Please be sure to read pressure
requirement carefully.
In normal use, the nozzle wings are
hor i z on t al as shown here. This pro v ides
a ver t i c al fan-shaped pat t ern which gives
max i m um, even ma t e r i a l coverage as the
gun is moved back and forth par a l l el to the
sur f ace being fin i shed.
776-3758
FOR BEST PERFORMANCE, PLEASE BE SURE TO DO
THE FOL LOW ING BEFORE USING THIS SPRAY GUN
AdjusTmENTs
Air flow adjustment screw
Turn right to decrease flow,
left to increase.
sprAyiNg
Spray pattern may be in f i n ite l y adjusted
from round to flat.
fluid control screw
Turn right to decrease flow,
left to increase.
spray width adjustment screw
Turn right for round, left for fan.
Set inlet pressure at no more than 43 psig. For op t i m um
per f or m ance, some ma t e r i a ls may spray better at psig
ratings below 43 psig. If unsure, always test at psig ratings
before using on final production. Try spray. If it is too fine,
de c rease the air pres s ure or open fluid control screw. If the
spray is too thick, close the fluid control screw. Reg u l ate the
pat t ern width and repeat ad j ust m ent of spray as needed.
5
Air pressure regulator
Turn right to decrease air pressure,
left to increase.
Rev. 07/21/14