Safety Information - Nemaxx BT55 Mode D'emploi

KEN001BT55
SAFETY INFORMATIONS
• Carefully read the instruction manual and pay attention to the following safety
instructions.
• Keep the instruction manual for future reference.
• Check whether the mains voltage matches the one on the label of the device.
• Don´t pull the mains plug in order to unplug the device from the socket.
• Make sure not to damage or run over cables when moving the device.
• The socket has to be earthed and appropriately secured.
• The dehumidifier must not be covered when used.
Don´t put clothes or other objects on it.
• Only use the dehumidifier on sturdy and even ground.
• Repairs must be carried out by qualified experts with appropriate knowledge about the
product.
• Don´t use adapters, additional connections or connecting plugs to connect the device
with an electricity supply.
• Don´t put the device close to sources of heat, like radiators, radiant heaters, etc.
• Don´t expose the product to direct sunlight or bad weather, like wind, storms and rain.
• Unplug the device if problems like smell of burning occur while using it.
• Don´t use the product close to chemicals and acids.
Those might damage the collection container or even the whole device.
• Unplug the device if it is not used for a longer period or you want to clean it.
• If you want to use permanent drainage, make sure that the hose is not bended and the
water can fl ow through unhindered.
Don´t use permanent drainage when tempe-ratures are very low and the water could
freeze.
• Protect the device from splashing water.
• Only use an earthed standard socket with a 220-240V AC connection.
• Make sure that neither dryer, nor mains plug, nor socket is dusty.
• This appliance is intended to be used by expert or trained users in shops, in light industry
and on farms, or for commercial use by lay persons.
• The A-weighted emission sound pressure level at workstations does not exceed 70dB;
the peak C-weighted instantaneous sound pressure value at workstations does not
exceed 63Pa.
• The product should be used on the back from the wall a distance of at least 50 cm,
the side away from the wall at least 30 cm.
EN
3
Version: 3.0
19.07.2017