After Use - Dexter 20VJS2-28.1 Mode D'emploi

5. OPERATION
ADJUSTING OF SELECTOR OF AIR BLOW
1. To get clear view in cutting when the selector of air blow set to "1".
2. To achieve better dust removal efficiency for vacuum cleaner when the selector of air blow set
to "0".
WARNING! During operation fine dust will be generated!
These dusts are highly inflammable and explosive! Do not smoke during operation, keep
heat sources and open flames out of the working area!
Always wear a dust mask to protect yourself against hazards resulting from fine dust!
CUTTING
NOTE: Take the cutting channel into consideration when cutting along marked cutting lines. Do not
cut directly on the line but next to it.
It is recommended to make a trial cut before working on the actual workpiece to determine the
position and width of the cutting channel, especially after replacing the blade or changing bevel angle.
Switch the product off, let it come to a complete stop and remove battery pack if the saw blade gets
stuck in the workpiece. Only then free the jammed blade.
3. Cut in the direction of the wood grain whenever possible to avoid jamming the saw blade and
fraying edges.
4. Always add cooling liquid along the cutting line to reduce heat when cutting metal.
5. Ensure that there is sufficient clearance for the saw blade under the workpiece.
6. Hold the product with one hand on the handle, and with the other hand on the gripping surface.
7. Switch the product on and wait until it runs at full speed before placing it on the workpiece.
8. Carefully lead the product toward the workpiece. Place the base plate flat on the workpiece and
push the product at an even speed.
9. Only apply as much forward and vertical pressure as necessary to keep the product flat on the
workpiece. Higher pressure will not increase but lower the performance of the product and
leads to uneven results.
10. Keep the product moving at all times, do not stop in one position to avoid grooves.
11. Lift the product from the workpiece before switching it off.

AFTER USE

1. Switch the product off, wait for complete stop, remove battery pack, let it cool down and
remove the blade.
2. Check, clean and store the product as described below.
FR FR
ES ES
PT PT
IT IT
EL EL
PL PL
RU RU
UA KZ
KZ UA
RO RO
BR BR
EN
EN
335