Details Of Selector Valve Version With Sand Filter Only - Teuco 630 Manuel De L'utilisateur

DETAILS OF SELECTOR VALVE
VERSION WITH SAND FILTER ONLY
1. Filter
Position of valve during normal filtration.
Water is directed into the filter, through the sand bed
and back to the pool.
2. Backwash
Position of valve allowing reverse flow through the
filter for cleaning purposes. Water is pumped into
the filter from the bottom, up through the sand bed
to remove the impurities, and out of the top directly
to the drain.
3. Rinse
Position of valve selected following backwash, to
flush the filter bed. Water is pumped into the filter
from the top, down through the sand bed and out of
the bottom directly to the drain.
4. Waste
Position of valve allowing excess water to drain from
the overflow tank.
When the amount of water in the overflow tank has
been swollen by rain, run the filter pump until the
"H O ON" message appears in the display, then
2
shut off the pump and return the valve to the "filter"
position. The excess water is diverted from the pump
directly to the drain, without passing through the filter.
5. Recirculate
Position of valve allowing circulation of a treatment
chemical, without filtration.
Water is returned directly to the pool, without passing
through the filter.
6. Closet
Position of valve when the ports are closed.
Water does not pass through the filter.
0.
During periods when the pool is not in use, set
the selector valve to the intermediate position
indicated by "off".
630
00:00 01/12/2012
WEEK-END
FILTER ON H O ON
2
TIMER=01.00 H:M
1
EN
45