Nutri Ninja BL450EU Notice D'utilisation page 23

10. DO NOT USE if the appliance is not working, has
been dropped, dropped into water, damaged or
left outdoors.
11. NO SERVICEABLE PARTS. Incorrect re-
assembly or repair can cause a risk of electrical
shock or injury to persons when the appliance is
used. Contact Customer Service.
12. If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
13. DO NOT let the power cord hang over the edge of
table or counter or touch hot surfaces such as the
stove.
14. Always use the appliance on a dry, level surface.
15. Keep hands, hair, clothing, as well as utensils
out of container while processing or blending
to reduce the risk of severe injury to persons or
damage to the appliance. A scraper may be used
but only when the appliance is not running.
16. Avoid contact with moving parts.
17. DO NOT attempt to sharpen blades.
18. DO NOT use the appliance if blade assembly is
bent or damaged.
19. To reduce the risk of injury, never attempt to place
the Pro Extractor Blades
without first assembling the Pro Extractor Blades
to the Nutri Ninja Cup.
20. DO NOT operate this appliance on or near any hot
surfaces (such as gas or electric burner or in a
heated oven).
21. The use of attachments or accessories
including canning jars, not recommended by the
manufacturer may result in fire, electric shock or
personal injury.
onto the motor base
™
22. DO NOT remove any container from the motor
base while the appliance is in operation. Always
unplug the unit when not in use.
23. To reduce the risk of injury, NEVER operate the
appliance without the blade assembly in place;
DO NOT try to defeat the interlock mechanism;
make sure that the attachment is properly
installed before operating the appliance.
24. DO NOT expose containers to extreme
temperature changes.
25. DO NOT overfill. Do not exceed "MAX" fill line.
26. DO NOT operate the appliance empty.
27. If the appliance overheats, a thermal switch will
become activated and shut off the motor. To
reset, unplug the appliance and let it cool down
for approximately 30 minutes before using again.
28. To reduce the risk of burns, always allow the
appliance to cool before taking off parts and
before cleaning.
29. Max ON time is 1 minute under 900W load. If
the appliance overheats, a thermal switch will
become activated and shut off the motor. To
reset, unplug the appliance and let it cool down
for approximately 30 minutes before using again.
30. THIS PRODUCT IS INTENDED FOR
HOUSEHOLD USE ONLY. Do not use this
appliance for anything other than its intended use.
Do not use outdoors.
31. Appliance accessories are not intended to be
used in the microwave as it may result in damage
to the accessories.
SAVE THESE
INSTRUCTIONS
www.ninjakitchen.eu 23