Dometic GROUP WAECO CoolMatic HDC-150 Instructions De Montage Et De Service page 39

Réfrigérateur encastrable à compresseur
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 45
_HDC150.book Seite 39 Donnerstag, 9. Dezember 2010 8:19 20
HDC-150
A slight film of frost, or droplets of water, could be deposited in the interior of
the refrigerator when it has been cooling for longer periods. This is normal
because the moisture in the air condenses to water when the temperature in
the cooler falls. The refrigerator is not defective. Wipe it out with a dry cloth.
If the film of frost is thicker than 3 mm, you should defrost the refrigerator
compartment.
Defrosting the refrigerator (HDC-150L only)
Proceed as follows to defrost the refrigerator:
➤ Empty the contents.
➤ If necessary, put them in another cooling device to keep them chilled.
➤ Switch the refrigerator off using the switch (fig. 2 1, page 4).
➤ Open the doors.
➤ Clean the water run-off at the rear of the refrigerator.
➤ Wipe off the condensate.
Defrosting the refrigerator (HDC-150DF, HDC-150FF only)
NOTICE!
A
Never use hard or sharp tools to remove ice or to free objects
frozen onto the device.
This can damage the refrigerator.
Proceed as follows to de-ice the refrigerator:
➤ Switch the refrigerator to level "5" 24 hours before de-icing using the
thermostat (fig. 2 2, page 4).
➤ Empty the contents.
➤ If necessary, put them in another cooling device to keep them chilled.
➤ Disconnect the power supply.
➤ Open the door.
➤ Place a water container under the water run-off at the rear of the refriger-
ator to collect the condensate.
➤ Once the ice has melted completely, clean the refrigerator (see chapter
"Cleaning and maintenance" on page 40).
➤ Reconnect the refrigerator to the power.
Using the refrigerator
39

Publicité

Table des Matières
loading

Table des Matières