Alarm Configuration - Bodet HARMONYS LINE Notice D'installation Et D'utilisation

EN
3.4 Alarm configuration
This page is used to enable device supervision, to define the information to be transmitted
and the destination server. One or more settings can be defined and configured as alarms.
The following information is displayed:
- Enable SNMP checkbox: activates the SNMP network service for device supervision from a control PC.
- Version: choice of SNMP protocol version.
- Community: A set of clocks defined by the user. All the clocks on the network must have the same Community
name.
- Tick SNMP Trap box: activates (or not) the automatic sending of error messages to SNMP managers.
- SNMP Manager 1/2/3 : IP addresses of servers receiving alerts from the clocks. SNMP Manager redundancy
increases the reliability of alerts.
- Reboot: This setting is used to detect a clock reboot.
- Scheduled melody: This parameter triggers an alarm when a programmed melody is played.
- Manual melody: This parameter is used to trigger an alarm when melody is initiated manually.
- Streaming: the device sends back the information that an audio stream is in process of being played.
- Alert melody: This parameter triggers an alarm when an alert melody is played.
- Missing melody: This parameter sets off an alarm when a played melody is missing.
- Web access: This setting is used to trigger an alert if a user connects to the web server of the clock.
- Authentication failure: This setting is used to trigger an alert if a user sends an incorrect ID to the web server of
the clock.
- Repeater failure: This parameter triggers an alarm when a fault occurs on the repeater.
- Periodic Status: This setting is used to verify that the device is still working correctly. This verification is carried out
at a set frequency.
8