Product Maintenance - Fellowes Powershred 325Ci Instructions D'utilisation

PRODUCT MAINTENANCE

CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare occasions the sensors may become blocked by paper dust causing the motor to run
even if there is no paper present.
(Note: two paper detection sensors are located in the center of the paper entry)
TO CLEAN THE SENSORS
1 2
Turn off and unplug Locate Auto-start
shredder infrared sensor
OILING SHREDDER
noise when shredding and could ultimately stop running. To avoid these problems, we recommend you oil your shredder each time you
empty your waste bin.
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1
2
Press and hold forward
*Apply oil across entry
( ) 2-3 seconds
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
PREVENTIVE MAINTENANCE & ACCESSORIES
TROUBLESHOOTING
Bin Full Indicator: When illuminated, the shredder waste bin is full and needs to be emptied. Use Fellowes waste bag 36056.
SafeSense Indicator: If hands are too close to the paper entry, the SafeSense
®
is active for 3 seconds, the shredder will automatically turn off and the user must press the power button on the control panel to resume shredding.
Remove Paper Indicator: When illuminated, press reverse (
Door Open Indicator: The shredder will not run if the cabinet door is open. When illuminated, close the door to resume shredding.
Straight Feed Indicator: When illuminated, remove paper and feed straight into paper entry.
4
.
3 4
Dip cotton swab in Using cotton swab, wipe
rubbing alcohol away any contamination
from the paper sensors
indicator will illuminate and the shredder will stop shredding. If SafeSense
®
ENGLISH
Models 325Ci/325i
®