Ironing With Steam; After Ironing; Cleaning; Technical Data - MIA DB 8472 K Mode D'emploi

Table des Matières

Publicité

Ironing with steam

Steam ironing is possible only at higher temperatures. Set the temperature control to high temperature
max. Let iron heat up fully by setting the temperature control to level max.
Hold the iron in horizontal position so that steam can exhaust from the nozzles into the soleplate.
In vertical position steaming is possible also.
Push the steam button below the handle. If you hold the steam button pushed permanently, steam will
exhaust permanently. Steaming stops as soon as the steam button has been released.
Note: Water may leak from the soleplate if the temperature is too low. If so, set the temperature control
to a higher temperature level. Also steam pressure will get less if you use low temperature. In this case
pushing on the steam button will be without result.
Dry function
For dry ironing do not push the steam button.

After ironing

Put the temperature control to "min" position and unplug.
Let the iron cool down.
Empty the water tank and the iron completely, to remove any residual water. This avoids lime stone
inside. In order to store, place the iron back on its stand.
C
l
e
a
n
i
n
g
C
l
e
a
n
i
n
g
Caution! Danger of electrical shock! Never immerse the appliance, the cord or connector parts into
water. The connector and electrical parts must not get wet. Contact of electrical parts with moisture causes
short circuit and damage. Unplug the appliance after each use and before cleaning, or storing it.
Caution! Danger of serious burns! Let the appliance cool down completely, before cleaning
and storing it.
Always ensure that it is completely cold before removing lime and fuzz on the sole plate with a soft
dry cloth.
Never use sharp detergents or abrasive material like metallic cleaning objects to clean the plastic
housing or the stain less steel sole plate as sensitive surfaces might get scratches and get damaged.
Do not put vinegar or other descaling agents into the water reservoir, it is not suited for this and might
get damaged. Do not use chemically descaled water. Aftre each use, empty the water tank and the
iron completely to avoid lime residues. From tiome to time change the anti-lime filter. Therefore please
read chapter "How to use and tips, "anti-lime filter".
Do not wind the cable around the appliance while it is hot. Never store the cable before the appliance
has cooled down completely.
Store the appliance in a dry place which is not reachable for small children.
T
e
c
h
n
i
c
a
l
d
a
t
a
T
e
c
h
n
i
c
a
l
d
a
t
a
230V~ 50Hz 2200W
The unit is tested according to GS and corresponds to CE directives.
D
i
s
p
o
s
a
l
D
i
s
p
o
s
a
l
Notice for environmental: If at any time in the future you should need to dispose of this product please
note that waste electrical products should not be disposed of with household waste. The symbol
(crossed dustbin) on the packing is indicating it. Please recycle where facilities exist. Check with
your local authority or retailer for recycling advice. (Waste Electrical and Electronic Equipment
Directive)
11

Publicité

Chapitres

Table des Matières
loading

Table des Matières