Cleaning And Maintaining The Appliance; Emptying The Dust Container - SEVERIN HV 7146 Mode D'emploi

c
lEaninG anD mainTaininG ThE appliancE
Vacuuming in Power mode
The appliance vacuums at full power in Power mode. The brush roller also rotates if the floor nozzle is
attached.
1. Attach an additional attachment to the appliance if necessary.
2. Push the On/Off switch to the "I" position to switch on the appliance.
The appliance vacuums in Eco mode.
–
The LED on the handle lights up orange.
–
The LEDs on the top of the appliance illuminate the work area.
–
3. Push the On/Off switch to the "II" position to switch the appliance to Power mode.
The appliance vacuums in Power mode.
–
All LEDs remain illuminated.
–
TIP: Push the On/off switch back to the "I" position to return to Eco mode.
–
4. Vacuum the surface.
5. Push the On/Off switch to the "0" position to switch off the appliance.
6. Empty and clean the dust container ("Cleaning the dust container and filter" on page 27).
TIP: The LED on the handle starts flashing orange when the battery charge is running low. The appli-
ance switches off automatically when the battery charge is too low. Charge the rechargeable battery
("3 Installing and charging the appliance" on page 24).

4 Cleaning and maintaining the appliance

For additional information on cleaning, see  illustrated Quick Start Guide.

Emptying the dust container

The dust container can only store limited quantities of dirt/water. For this reason, empty the dust container after
each cleaning procedure or if the dust or liquid reach the MAX mark.
2
26
1. Make sure that the appliance is switched off and is not on charge.
2. Hold the appliance with the suction opening facing down.
3. Press the release catch to disconnect the dust container from the
motor unit.
4. Remove the dust container.
5. Remove the filter and filter holder.
6. Empty the dust container into a waste bin or a drain.