Cleaner Maintenance - Hoover FREESPACE Nanopack Instructions D'utilisation

Freespace_bag_nanopack_V3.qxp
Nanopack Storage System - The unique Nanopack Storage System allows the
cleaner to be stored in an ultra compact configuration with a significantly smaller
storage volume than other cleaners.
To store the cleaner using the Nanopack system:
1. Detach the floor nozzle and hose handle from the Tritube then collapse the Tritube
to its minimum storage length (see 'Telescopic Tritube').
2. Position the cleaner in the upright position and slot the tool storage bracket on the
Tritube into the recess located on the base of the cleaner (P15).
3. Wrap the hose around the product before fitting the hose handle and floor
nozzle into the locations provided on the tool storage bracket (P16).

CLEANER MAINTENANCE:

Replacing the dust bag (depending on model - If the bag check indicator is
illuminated (P17) please check and, if necessary, replace the dust bag.
1. Remove the hose from the cleaner (P1).
2. Press buttons on handle (P18) and remove the bag door (P19).
3. Pull the bag collar to remove the dust bag (P20) and carefully dispose of the bag
into a bin.
4. Fit a new bag into the cleaner by inserting the bag collar into the bag holder.
Important: The hose must be removed before removing or replacing the dust bag.
Remember: The bag check indicator will also illuminate if an obstruction has occurred.
In this case refer to the section "Removing a blockage from the system".
Emptying the permanent dust bag (depending on model) - If the bag check
indicator is illuminated (P17) please check and if necessary, empty the permanent
dust bag.
1. Remove the hose from the cleaner (P1).
2. Press buttons on handle (P18) and remove the bag door (P19).
3. Pull the bag collar to remove the dust bag (P20) from the cleaner.
4. Remove the plastic guide at the end of the bag allowing dirt collected to fall into
the bin (P21).
5. Return the guide back into the original position.
6. Replace the permanent dust bag by inserting the bag collar into the bag holder.
7. Check the filters for excessive build up of dust and if necessary clean the
washable filter (see 'Cleaning the washable filters').
Removing the pre-motor and exhaust filters
To remove the pre-motor filter (HEPA or Purefilt, depending on model):
1. Open the bag door and remove the dust bag from the cleaner (see 'Replacing the
dust bag').
2. Press the latch at the top of the pre-motor filter frame to unlock it from the cleaner.
Tilt then remove the filter from the cleaner (P22).
13/03/2007 12:38 Page 3
3
GB