Table des Matières
Publicité
Basin: Sediment may build up in basin causing pump to oper-
ate improperly. Remove 10 1/4-20 screws from cover. Remove
cord grommet and loosen cords to allow slack and then remove
cover.
Remove pump and clean basin using a mild detergent and water.
Reassemble in reverse order.
Torque screws 18–20 in.-lbs.
If pump alignment plate is removed, it must be reinstalled per
pump alignment diagram.
Figure 1 - Typical Installation
2
Pump: Sediment or lint can clog pump and cause improper
operation. If necessary, remove pump and pull off the pressed-
in screen. Clean using a mild detergent and water and reinstall.
Plastic pump base may also be removed to clean around impeller
and inside base. Remove the six base screws and clean base
using a mild detergent and water. Do not remove impeller. When
reinstalling base, be sure seal ring is seated properly in groove
and torque screws to 10–15 in.-lbs. See pump manual for other
information. For any other pump repair, return the pump to a Little
Giant authorized service center.
Publicité
Table des Matières
